No more Negative time on ppt end

[Join me]

I just had my ppt end at 0min, half way through a turn,,,
normally the ppt clock goes into negative time and your still on ppt until the turn changes.

Can anyone else confirm?

Are their anymore updates?

[Sarevok]

Is defiantly a recent update if it occurs for anyone else. I'll check when my next PPT runs out

[Rudy Peña]

Its been like this for a few years.

[Clarkey]

Its been like this for a few years.

No it has not.

When PPT ends mid turn it always goes -0, -1, -2 until it gets to turn change then drops off.

I haven't noticed PPT dropping off mid turn when it gets to 0 recently, but that's because I keep ending my PPT's early.

[1horseman]

I am Protected for: -2 minutes.

[Join me]

I was neg. tuesday when I came off

Thanks,,, I was thinking more recent, like after my post

I am Protected for: -2 minutes.

Thank you, this is what I was looking for,,,

May have just happened to me once, but I was online watching it,,, and I went from 0 min to not on protection,,,
Will post if it happens again.

[Sarevok]

If it does, go to an attack page. See if the test is just removed, but your still protected

[Stickm@n]

When PPT ends mid turn it always goes -0, -1, -2 until it gets to turn change

That happens
Then at the turn change your PPT ends, not when it hits 0 mins.

It's been like that for as long as I can remember.

[Clarkey]

When PPT ends mid turn it always goes -0, -1, -2 until it gets to turn change

That happens
Then at the turn change your PPT ends, not when it hits 0 mins.

It's been like that for as long as I can remember.

Yes I know that's my point. You need to read the thread again.

[Stickm@n]

When PPT ends mid turn it always goes -0, -1, -2 until it gets to turn change

That happens
Then at the turn change your PPT ends, not when it hits 0 mins.

It's been like that for as long as I can remember.

Yes I know that's my point. You need to read the thread again.

My bad.

[Clarkey]

When PPT ends mid turn it always goes -0, -1, -2 until it gets to turn change

That happens
Then at the turn change your PPT ends, not when it hits 0 mins.

It's been like that for as long as I can remember.

Yes I know that's my point. You need to read the thread again.

My bad.

No worries.

[Casshern]

well my last ppt went through til turn change last time