Page 1 of 1
No more Negative time on ppt end
Posted: Thu Aug 06, 2009 12:03 am
by Join me
I just had my ppt end at 0min, half way through a turn,,,
normally the ppt clock goes into negative time and your still on ppt until the turn changes.
Can anyone else confirm?
Are their anymore updates?
Re: No more Negative time on ppt end
Posted: Thu Aug 06, 2009 6:13 am
by Sarevok
Is defiantly a recent update if it occurs for anyone else. I'll check when my next PPT runs out
Re: No more Negative time on ppt end
Posted: Thu Aug 06, 2009 11:41 am
by Rudy Peña
Its been like this for a few years.
Re: No more Negative time on ppt end
Posted: Thu Aug 06, 2009 1:18 pm
by Clarkey
Rudy Pena wrote:Its been like this for a few years.
No it has not.
When PPT ends mid turn it always goes -0, -1, -2 until it gets to turn change then drops off.
I haven't noticed PPT dropping off mid turn when it gets to 0 recently, but that's because I keep ending my PPT's early.
Re: No more Negative time on ppt end
Posted: Thu Aug 06, 2009 1:46 pm
by 1horseman
I am Protected for: -2 minutes.
Re: No more Negative time on ppt end
Posted: Thu Aug 06, 2009 2:37 pm
by Join me
SuperSaiyan wrote:I was neg. tuesday when I came off
Thanks,,, I was thinking more recent, like after my post
1horseman wrote:I am Protected for: -2 minutes.
Thank you, this is what I was looking for,,,
May have just happened to me once, but I was online watching it,,, and I went from 0 min to not on protection,,,
Will post if it happens again.
Re: No more Negative time on ppt end
Posted: Thu Aug 06, 2009 11:01 pm
by Sarevok
If it does, go to an attack page. See if the test is just removed, but your still protected
Re: No more Negative time on ppt end
Posted: Fri Aug 07, 2009 1:34 am
by Stickm@n
Clarkey wrote:When PPT ends mid turn it always goes -0, -1, -2 until it gets to turn change
That happens
Then at the turn change your PPT ends, not when it hits 0 mins.
It's been like that for as long as I can remember.
Re: No more Negative time on ppt end
Posted: Fri Aug 07, 2009 2:36 am
by Clarkey
Stickman wrote:Clarkey wrote:When PPT ends mid turn it always goes -0, -1, -2 until it gets to turn change
That happens
Then at the turn change your PPT ends, not when it hits 0 mins.
It's been like that for as long as I can remember.
Yes I know that's my point. You need to read the thread again.
Re: No more Negative time on ppt end
Posted: Fri Aug 07, 2009 3:01 am
by Stickm@n
Clarkey wrote:Stickman wrote:Clarkey wrote:When PPT ends mid turn it always goes -0, -1, -2 until it gets to turn change
That happens
Then at the turn change your PPT ends, not when it hits 0 mins.
It's been like that for as long as I can remember.
Yes I know that's my point. You need to read the thread again.
My bad.
](./images/smilies/eusa_wall.gif "Brick wall")
Re: No more Negative time on ppt end
Posted: Fri Aug 07, 2009 3:07 am
by Clarkey
Stickman wrote:Clarkey wrote:Stickman wrote:Clarkey wrote:When PPT ends mid turn it always goes -0, -1, -2 until it gets to turn change
That happens
Then at the turn change your PPT ends, not when it hits 0 mins.
It's been like that for as long as I can remember.
Yes I know that's my point. You need to read the thread again.
My bad.
No worries.
Re: No more Negative time on ppt end
Posted: Sun Aug 09, 2009 4:31 am
by Casshern
well my last ppt went through til turn change last time